The green pieces are fed into a sintering furnace until they reach the necessary final strengths, densities, and dimensional stability.
In the process of sintering, temperatures below the melting point of the main powder component of the part are heated in a protected environment to molecularly connect the metal powder particles that make up the part.
The size and strength of the contacts points between the compressed particles grow to enhance the component's technical characteristics.
In order to meet the final component parameters, sintering might shrink, expand, improve conductivity, and/or make the part tougher depending on the process design.
In a sintering furnace, the components are put on a continuous conveyor and slowly transported through the furnace's chambers to accomplish three main tasks.
To eliminate undesired lubricants added to the powder during the compaction process, the pieces are first slowly heated.
The parts next proceed to the high heat zone of the furnace, where the final qualities of the parts are determined at precisely controlled temperatures ranging from 1450° to 2400°.
By carefully balancing the atmosphere inside this furnace chamber, certain gases are added to decrease existing oxides and stop additional oxidation of the parts during this high heat phase.
To complete the pieces or get them ready for any additional processes, they finally go through a cooling chamber. Depending on the materials used and the size of the components, the entire cycle may take 45 minutes to 1.5 hours.
Profession and reliability.
Our advantages are multiple available technologies, strong quality assurance, and expertise in project & supply chain management.
There is no additional cost above the product and tooling price except for third-party services.
First, all of our supply partners have undergone a series of screening and audit processes; we can provide complete audit reports to you.
Secondly, if you want to perform your own independent supplier audit procedure, our representatives can accompany and assist you to achieve it.
a. With our partners, we perform APQP at an early stage in each project.
b. Our factory must fully understand quality concerns from customers and implement product & process quality requirements.
c. Our quality professionals perform patrol inspections in our factories. We perform final inspections before goods are packed.
d. We have 3rd-party inspectors who perform final audit checks on packed goods prior to dispatch from China.
Of course! We take full responsibility for our products. If a test report confirms it was our fault, we will absolutely compensate you accordingly.
We enjoy growing together with all our clients, whether big or small.
You will become bigger and bigger partnering with us.